Home > Arduino & SCM Supplies > Raspberry
Raspberry Pi Sense HAT w/ Case for Raspberry Pi B+/2B/3B
The sensors enable you to read: Orientation (yaw£¬ pitch & roll) via an accelerometer£¬ 3D gyroscope£¬ and magnet ometer Pressure HumidityTemperature To Install: Connect your Sense HAT to the Raspberry Pi via the 40 GPIO Pins Open up a terminal and run the following command: (This will take approximately 5 minutes to run on the Raspberry Pi 2 Model B£¬ and approximately 20 minutes on earlier models of the Raspberry Pi)When the install is finished you will need to reboot your Raspberry Pi Note: The Raspberry Pi Sense HAT is compatible with the Raspberry Pi 3£¬ Raspberry Pi 2 £¬ and Raspberry Pi A+£¬ but NOT the earlier 26-pin models of Raspberry Pi 1 Model B & A's. Pi not included!